Minicube-II A1: Assembly
De WikiRobotics
Revisión del 11:33 23 feb 2011 de Obijuan (Discusión | contribuciones) (→Step 1: Screw the MY1 module to Unimod 2D B1)
Contenido
Introduction
Minicube-II is a minimal configuration. It is the modular robot with the minimum number of modules capable of moving in 2D.
To build it, the following parts are needed:
- One MY1 module (Assembly instructions)
- One Unimod 2D type B1 (Assembly instructions)
- 4 M3 bolts. Length: 8mm
- 4 M3 nuts
Assembling
Step 1: Screw the MY1 module to Unimod 2D B1
Pasos 2: Conectar el servo del Módulo MY1 a la Skycube
Conectar el servo del módulo a la Skycube. Se puede conectar en cualquiera de los conectores libres
¡MUY IMPORTANTE! Conectar el servo con la orientación correcta. El cable negro a GND |
Fotos
Álbum de fotos |
Enlaces
Noticias
- 19/Abril/2010: Primera versión de esta página