Unimod 2D-B1: Assembling
De WikiRobotics
Revisión del 10:58 23 feb 2011 de Obijuan (Discusión | contribuciones) (→Pasos 2: Conectar el servo del Módulo MY1 a la Skycube)
Contenido
Introduction
Unimod 2D is the minimal block that oscillates in two perpendicular planes. One module pitches and the other yaws. It is the minimal common element for building pitch-yaw modular snake robots.
To assemble it the following parts are needed:
- One MY1 module (Assembly instructions)
- One Unimod type B1 (Assembly instructions)
- 4 M3 bolts. Length: 8 mm
- 4 M3 nuts
Assembing
Step 1: Screw the MY1 module to Unimod B1
Step 2: Connect the module's servo to the Skycube board
Connect the module's servo to the Skycube board. It can be connected to any of the available 3-pin headers.
![]() |
Fotos
Álbum de fotos |
Enlaces
Noticias
- 19/Abril/2010: Primera version de esta página
- 16/Abril/2010: Comenzada esta página