Diferencia entre revisiones de «Minicube-II B1: Assembly»
De WikiRobotics
(→Pasos 2: Conectar el servo del Módulo MY1 a la Skycube) |
(→Introduction) |
||
Línea 12: | Línea 12: | ||
{| | {| | ||
− | || [[Imagen:Minicube-IIB-inicio-r2.jpg|thumb|300px|'''Begining''': Parts needed to build Minicube-II type | + | || [[Imagen:Minicube-IIB-inicio-r2.jpg|thumb|300px|'''Begining''': Parts needed to build Minicube-II type B1 (''Click to enlarge'')]] |
|| [[Imagen:Minicube-IIB-fin-r2.jpg|thumb|300px|'''End''': Minicube-II finished (''Click to enlarge'')]]]] | || [[Imagen:Minicube-IIB-fin-r2.jpg|thumb|300px|'''End''': Minicube-II finished (''Click to enlarge'')]]]] | ||
|} | |} |
Revisión del 12:22 23 feb 2011
Contenido
Introduction
Minicube-II is a minimal configuration. It is the modular robot with the minimum number of modules capable of moving in 2D.
To build it, the following parts are needed:
- One MY1 module (Assembly instructions)
- One Unimod 2D type B1 (Assembly instructions)
- 4 M3 bolts. Length: 8mm
- 4 M3 nuts
]] |
Assembling
Step 1: Screw the MY1 module to Unimod 2D B1
Step 2: Connect the module's servo to the Skycube board
Connect the module's servo to the Skycube. It can be connected to any of the available headers.
![]() |
Fotos
Álbum de fotos |
Enlaces
Noticias
- 19/Abril/2010: Primera versión de esta página