Diferencia entre revisiones de «Minicube-II A1: Assembly»
De WikiRobotics
(→Fotos) |
(→Enlaces) |
||
Línea 46: | Línea 46: | ||
|} | |} | ||
− | == | + | == Links == |
− | * [[Robot Modular:Minicube-II]] | + | * [[Training on modular snake robots|Training on modular snake robots (Main page)]] |
+ | * [[Robot Modular:Minicube-II|The Minicube-II modular robot]] | ||
+ | * [[Unimod]] | ||
* [[Unimod 2D]] | * [[Unimod 2D]] | ||
− | + | * [[Módulos MY|MY1 modules]] | |
− | * [[Módulos MY]] | + | * [[Skycube|Skycube board]] |
− | * [[Skycube| | ||
== Noticias == | == Noticias == |
Revisión del 11:38 23 feb 2011
Contenido
Introduction
Minicube-II is a minimal configuration. It is the modular robot with the minimum number of modules capable of moving in 2D.
To build it, the following parts are needed:
- One MY1 module (Assembly instructions)
- One Unimod 2D type B1 (Assembly instructions)
- 4 M3 bolts. Length: 8mm
- 4 M3 nuts
Assembling
Step 1: Screw the MY1 module to Unimod 2D B1
Step 2: Connect the module's servo to the Skycube board
Connect the module's servo to the Skycube. It can be connected to any of the available headers.
![]() |
Pictures
Photo album |
Links
- Training on modular snake robots (Main page)
- The Minicube-II modular robot
- Unimod
- Unimod 2D
- MY1 modules
- Skycube board
Noticias
- 19/Abril/2010: Primera versión de esta página