Diferencia entre revisiones de «Minicube-II A1: Assembly»
De WikiRobotics
(→Pasos 2: Conectar el servo del Módulo MY1 a la Skycube) |
(→Step 2: Connect the module's servo to the Skycube board) |
||
Línea 32: | Línea 32: | ||
{| {{tablabonita}} | {| {{tablabonita}} | ||
− | | [[Imagen:Icono_aviso.png]] <font color=red> | + | | [[Imagen:Icono_aviso.png]] <font color=red>IMPORTANT!</font> Connect the servo in the right orientation. The black wire is connected to GND |
|} | |} | ||
Revisión del 11:36 23 feb 2011
Contenido
Introduction
Minicube-II is a minimal configuration. It is the modular robot with the minimum number of modules capable of moving in 2D.
To build it, the following parts are needed:
- One MY1 module (Assembly instructions)
- One Unimod 2D type B1 (Assembly instructions)
- 4 M3 bolts. Length: 8mm
- 4 M3 nuts
Assembling
Step 1: Screw the MY1 module to Unimod 2D B1
Step 2: Connect the module's servo to the Skycube board
Connect the module's servo to the Skycube. It can be connected to any of the available headers.
![]() |
Fotos
Álbum de fotos |
Enlaces
Noticias
- 19/Abril/2010: Primera versión de esta página