Diferencia entre revisiones de «Minicube-II A1: Assembly»

Revisión del 10:36 23 feb 2011

Minicube-II type A1 (Click to enlarge)

Minicube-II is a minimal configuration. It is the modular robot with the minimum number of modules capable of moving in 2D.

To build it, the following parts are needed:

Begining: Parts needed to build Minicube-II type A1 (Click to enlarge)

End: Minicube-II finished (Click to enlarge)

1) Place Unimod 2D-B1 and the MY1 module as shown in the figure (Click to enlarge)	2) Attach the MY1 module to Unimod 2D-B1 (Click to enlarge)
3) Screw the MY1 module to Unimod 2D-B1 (Click to enlarge)	4) Place the 4 bolts and nuts (Click to enlarge)

Connect the module's servo to the Skycube. It can be connected to any of the available headers.

IMPORTANT! Connect the servo in the right orientation. The black wire is connected to GND

1) Connect the MY1 module to the Skycube board (Click to enlarge)

2) The Minicube-II A1 is ready! (Click to enlarge)

@@ Línea 32: / Línea 32: @@
 {| {{tablabonita}}
-| [[Imagen:Icono_aviso.png]] <font color=red>IMPORTANT¡</font> Connect the servo in the right orientation. The black wire is connected to GND
+| [[Imagen:Icono_aviso.png]] <font color=red>IMPORTANT!</font> Connect the servo in the right orientation. The black wire is connected to GND
 |}