Diferencia entre revisiones de «Cube3: Assembling»
De WikiRobotics
(→Enlaces) |
(→Links) |
||
Línea 65: | Línea 65: | ||
== Links == | == Links == | ||
+ | * [[Training on modular snake robots|Training on modular snake robots (Main page)]] | ||
* [[Robot Modular: Cube3]] | * [[Robot Modular: Cube3]] | ||
* [[Robot Modular:Minicube-I|Minicube-I]] | * [[Robot Modular:Minicube-I|Minicube-I]] | ||
* [[Unimod]] | * [[Unimod]] | ||
− | * [[Módulos MY]] | + | * [[Módulos MY|MY1 modules]] |
− | * [[Skycube| | + | * [[Skycube|Skycube board]] |
== Noticias == | == Noticias == |
Revisión del 05:41 23 feb 2011
Contenido
Introduction
Cube3 is a 1D topology pitch-pitch modular robot. It consist of three modules. For assembling it the following parts are needed:
- One MY1 module (Assembly instructions)
- One Minicube-I robot (Minicube-I: Assembling)
- 4 M3 bolts
- 4 M3 nuts
Assembling
Step 0: Perform the previous assembly
To assembly Cube3 it is necessary to first build the following parts:
Step 1: Screw the module to Minicube-I
Step 2: Connect the servo to the Skycube board
Connect the module's servo to the Skycube board. It can be connected to any of the free 3-pin headers
![]() |
Step 3 (Optional) Secure the wires with cable ties
Optionally, cable ties can be used to secure the wires. This step is similar to Minicube-I:_Assembling#Step_3_.28Optional.29_Secure_the_cables_using_cable_ties
Pictures
Photo album |
Links
- Training on modular snake robots (Main page)
- Robot Modular: Cube3
- Minicube-I
- Unimod
- MY1 modules
- Skycube board
Noticias
- 03/Abril/2010: Primera versión terminada
- 31/Marzo/2010: Comenzada esta página