Diferencia entre revisiones de «Cube3: Assembling»
De WikiRobotics
(→Enlaces) |
(→Noticias) |
||
(No se muestra una edición intermedia del mismo usuario) | |||
Línea 65: | Línea 65: | ||
== Links == | == Links == | ||
+ | * [[Training on modular snake robots|Training on modular snake robots (Main page)]] | ||
* [[Robot Modular: Cube3]] | * [[Robot Modular: Cube3]] | ||
* [[Robot Modular:Minicube-I|Minicube-I]] | * [[Robot Modular:Minicube-I|Minicube-I]] | ||
* [[Unimod]] | * [[Unimod]] | ||
− | * [[Módulos MY]] | + | * [[Módulos MY|MY1 modules]] |
− | * [[Skycube| | + | * [[Skycube|Skycube board]] |
− | == | + | == News == |
− | * ''' | + | * '''23/Feb/2011''': This page is created! |
− | |||
[[Categoría:Robots modulares]] | [[Categoría:Robots modulares]] |
Revisión actual del 05:42 23 feb 2011
Contenido
Introduction
Cube3 is a 1D topology pitch-pitch modular robot. It consist of three modules. For assembling it the following parts are needed:
- One MY1 module (Assembly instructions)
- One Minicube-I robot (Minicube-I: Assembling)
- 4 M3 bolts
- 4 M3 nuts
Assembling
Step 0: Perform the previous assembly
To assembly Cube3 it is necessary to first build the following parts:
Step 1: Screw the module to Minicube-I
Step 2: Connect the servo to the Skycube board
Connect the module's servo to the Skycube board. It can be connected to any of the free 3-pin headers
![]() |
Step 3 (Optional) Secure the wires with cable ties
Optionally, cable ties can be used to secure the wires. This step is similar to Minicube-I:_Assembling#Step_3_.28Optional.29_Secure_the_cables_using_cable_ties
Pictures
Photo album |
Links
- Training on modular snake robots (Main page)
- Robot Modular: Cube3
- Minicube-I
- Unimod
- MY1 modules
- Skycube board
News
- 23/Feb/2011: This page is created!